C
ONFIGURING
THE
S
WITCH
3-190
Enabling CoS
Enable or disable Class of Service (CoS). Command Attributes.
Command Attributes
• Traffic Classes - Click to enable Class of Service. (Default: Enabled)
Web – Click Priority, Traffic Classes Status.
Figure 3-84. Enable Traffic Classes
Selecting the Queue Mode
You can set the switch to service the queues based on a strict rule that
requires all traffic in a higher priority queue to be processed before lower
priority queues are serviced, or use Weighted Round-Robin (WRR)
queuing that specifies a relative weight of each queue. WRR uses a
predefined relative weight for each queue that determines the percentage
of service time the switch services each queue before moving on to the
next queue. This prevents the head-of-line blocking that can occur with
strict priority queuing.
Command Attributes
• WRR - Weighted Round-Robin shares bandwidth at the egress ports
by using scheduling weights 1, 2, 4, 6, 8, 10, 12, 14 for queues 0 through
7 respectively. (This is the default selection.)
• Strict - Services the egress queues in sequential order, transmitting all
traffic in the higher priority queues before servicing lower priority
queues.
To Next Page
Loading...
Need help?
General
