VLAN C
OMMANDS
4-211
switchport mode private-vlan
Use this command to set the private VLAN mode for an interface. Use the
no form to restore the default setting.
Syntax
switchport mode private-vlan{host | promiscuous}
no switchport mode private-vlan
• host – This port type can subsequently be assigned to a
community VLAN.
• promiscuous – This port type can communicate with all other
promiscuous ports in the same primary VLAN, as well as with all
the ports in the associated secondary VLANs.
Default Setting
Normal VLAN
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• To assign a promiscuous port to a primary VLAN, use the
switchport private-vlan mapping command. To assign a host
port to a community VLAN, use the private-vlan host
association command.
Example
switchport private-vlan host-association
Use this command to associate an interface with a secondary VLAN. Use
the no form to remove this association.
Syntax
Console(config)#interface ethernet 1/2
Console(config-if)#switchport mode private-vlan promiscuous
Console(config-if)#exit
Console(config)#interface ethernet 1/3
Console(config-if)#switchport mode private-vlan host
Console(config-if)#
To Next Page
Loading...
Need help?
General
