C
OMMAND
L
INE
I
NTERFACE
4-72
Command Mode
Global Configuration
Command Usage
This command specifies time servers from which the switch will poll
for time updates when set to SNTP client mode. The client will poll the
time servers in the order specified until a response is received. It issues
time synchronization requests based on the interval set via the sntp
poll command.
Example
Related Commands
Related Commands (4-71)
sntp poll (4-72)
show sntp (4-73)
sntp poll
This command sets the interval between sending time requests when the
switch is set to SNTP client mode. Use the no form to restore to the
default.
Syntax
sntp poll seconds
no sntp poll
seconds - Interval between time requests. (Range: 16-16384 seconds)
Default Setting
16 seconds
Command Mode
Global Configuration
Example
Console(config)#sntp server 10.1.0.19
Console#
Console(config)#sntp poll 60
Console#
To Next Page
Loading...
Need help?
General
