SMC Networks TigerSwitch SMC6128L2 User Manual

C OMMAND L INE I NTERFACE
4-110
Example
dot1x timeout tx-period
This command sets the time that the switch waits during an authentication
session before re-transmitting an EAP packet. Use the no form to reset to
the default value.
Syntax
dot1x timeout tx-period seconds
no dot1x timeout tx-period
seconds - The number of seconds. (Range: 1-65535)
Default
30 seconds
Command Mode
Interface Configuration
Example
show dot1x
This command shows general port authentication related settings on the
switch or a specific interface.
Syntax
show dot1x [statistics] [interface interface]
• statistics - Displays dot1x status for each port.
•interface
• ethernet unit/port
- unit - Stack unit. (Always unit 1)
- port - Port number. (Range: 1-28)
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout re-authperiod 300
Console(config-if)#
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout tx-period 300
Console(config-if)#

SMC Networks TigerSwitch SMC6128L2 Specifications

General

Brand	SMC Networks
Model	TigerSwitch SMC6128L2
Category	Switch
Language	English