SNMP C
OMMANDS
4-123
Example
show access-group
This command shows the port assignments of ACLs.
Command Mode
Privileged Executive
Example
SNMP Commands
Controls access to this switch from management stations using the Simple
Network Management Protocol (SNMP), as well as the error types sent to
trap managers.
SNMP Version 3 provides security features that cover message integrity,
authentication, and encryption; as well as controlling user access to specific
areas of the MIB tree. To use SNMPv3, first set an SNMP engine ID (or
accept the default), specify read and write access views for the MIB tree,
configure SNMP user groups with the required security model (i.e., SNMP
Console#show access-list
IP standard access-list david:
permit host 10.1.1.21
permit 168.92.0.0 0.0.15.255
IP extended access-list bob:
permit 10.7.1.1 255.255.255.0 any
permit 192.168.1.0 255.255.255.0 any destination-port 80 80
permit 192.168.1.0 255.255.255.0 any protocol tcp control-code 2 2
IP access-list jerry:
permit any host 00-30-29-94-34-de ethertype 800 800
IP extended access-list A6:
deny tcp any any control-flag 2 2
permit any any
IP ingress mask ACL:
mask protocol any any control-flag 2
Console#
Console#show access-group
Interface ethernet 1/25
IP standard access-list david
IP access-list jerry
Console#
To Next Page
Loading...
Need help?
General
