C
OMMAND
L
INE
I
NTERFACE
4-198
Default Setting
By default only VLAN 1 exists and is active.
Command Mode
VLAN Database Configuration
Command Usage
• no vlan vlan-id deletes the VLAN.
• no vlan vlan-id name removes the VLAN name.
• no vlan vlan-id state returns the VLAN to the default state
(i.e., active).
• You can configure up to 255 VLANs on the switch.
Example
The following example adds a VLAN, using VLAN ID 105 and name
RD5. The VLAN is activated by default.
Related Commands
show vlan (4 -206)
Configuring VLAN Interfaces
Console(config)#vlan database
Console(config-vlan)#vlan 105 name RD5 media ethernet
Console(config-vlan)#
Table 4-56 Configuring VLAN Interfaces
Command Function Mode Page
interface vlan Enters interface configuration mode for
a specified VLAN
IC 4-199
switchport mode Configures VLAN membership mode
for an interface
IC 4-200
switchport
acceptable-frame-types
Configures frame types to be accepted
by an interface
IC 4-200
switchport
ingress-filtering
Enables ingress filtering on an interface IC 4-202
To Next Page
Loading...
Need help?
General
