S
YSTEM
M
ANAGEMENT
C
OMMANDS
4-37
• The encrypted password is required for compatibility with legacy
password settings (i.e., plain text or encrypted) when reading the
configuration file during system bootup or when downloading the
configuration file from a TFTP server. There is no need for you to
manually configure encrypted passwords.
Example
Related Commands
enable (4-27)
authentication enable (4-93)
IP Filter Commands
management
This command specifies the client IP addresses that are allowed
management access to the switch through various protocols. Use the no
form to restore the default setting.
Syntax
[no] management {all-client | http-client | snmp-client |
telnet-client} start-address [end-address]
• all-client - Adds IP address(es) to the SNMP, web and Telnet
groups.
• http-client - Adds IP address(es) to the web group.
• snmp-client - Adds IP address(es) to the SNMP group.
• telnet-client - Adds IP address(es) to the Telnet group.
• start-address - A single IP address, or the starting address of a range.
Console(config)#enable password level 15 0 admin
Console(config)#
Table 4-11 IP Filter Commands
Command Function Mode Page
management Configures IP addresses that are allowed
management access
GC 4-37
show management Displays the switch to be monitored or
configured from a browser
PE 4-39
To Next Page
Loading...
Need help?
General
