SMC Networks TigerSwitch SMC6128L2 User Manual

606 pages

To Next Page

To Previous Page

VLAN C

OMMANDS

4-199

interface vlan

This command enters interface configuration mode for VLANs, which is

used to configure VLAN parameters for a physical interface.

Syntax

interface vlan vlan-id

vlan-id - ID of the configured VLAN. (Range: 1-4093, no leading

zeroes)

Default Setting

None

Command Mode

Global Configuration

Example

The following example shows how to set the interface configuration mode

to VLAN 1, and then assign an IP address to the VLAN:

Related Commands

shutdown (4 -149)

switchport native vlan Configures the PVID (native VLAN) of

an interface

IC 4-203

switchport allowed

vlan

Configures the VLANs associated with

an interface

IC 4-204

switchport gvrp Enables GVRP for an interface IC 4-216

switchport forbidden

vlan

Configures forbidden VLANs for an

interface

IC 4-205

switchport priority

default

Sets a port priority for incoming

untagged frames

IC 4-220

Console(config)#interface vlan 1

Console(config-if)#ip address 192.168.1.254 255.255.255.0

Console(config-if)#

Table 4-56 Configuring VLAN Interfaces

Command Function Mode Page

Other manuals for SMC Networks TigerSwitch SMC6128L2

Specifications2 pages

Questions and Answers:

G
Gregory ButlerAug 10, 2025
What to do if I cannot connect to SMC Networks TigerSwitch SMC6128L2 Switch using Secure Shell?
- S
  Sara King DVMAug 10, 2025
  If you are unable to connect to the SMC Networks Switch using Secure Shell, consider these potential causes. First, you might have exceeded the maximum permitted concurrent Telnet/SSH sessions, so try connecting again later. Also, ensure the SSH server's control parameters are correctly configured on the switch and that the SSH client software is properly configured on your management station. Verify that you've generated a public key on the switch and exported it to the SSH client. Make sure you've set up an account on the switch for each SSH user, including their username, authentication level, and password. Lastly, if using public key authentication, confirm that you've imported the client's public key to the switch.
D
Dr. Amanda BrownAug 20, 2025
How to access the on-board configuration program of SMC Networks Switch via a serial port connection?
- R
  rachelharveyAug 20, 2025
  To access the on-board configuration program of the SMC Networks Switch via a serial port connection, ensure your terminal emulator program is set to VT100 compatible, with 8 data bits, 1 stop bit, no parity, and the baud rate is set to 9600, 19200, 38400, 57600, or 115200 bps. Also, check that the null-modem serial cable conforms to the pin-out connections.

SMC Networks TigerSwitch SMC6128L2 Specifications

General

Model	SMC6128L2
Port Speed	10/100/1000 Mbps
Switching Capacity	56 Gbps
MAC Address Table Size	8K
Jumbo Frame Support	Yes
Manageable	Yes
Power Supply	Internal
Power Consumption	30 W
Weight	2.5 kg
Type	Switch
Jumbo Frame Support Size	9216 bytes
Forwarding Rate	41.7 Mpps