SMC Networks TigerSwitch SMC6128L2 User Manual

C OMMAND L INE I NTERFACE
4-282
cluster member
This command configures a Candidate switch as a cluster Member. Use the
no form to remove a Member switch from the cluster.
Syntax
cluster member mac-address <mac-address> id <member-id>
no cluster member mac-address <member-id>
- mac-address - The MAC address of the Candidate switch.
- member-id - The ID number to assign to the Member switch.
(Range: 1-36)
Default Setting
No Members
Command Mode
Global Configuration
Command Usage
• The maximum number of cluster Members is 36.
• The maximum number of switch Candidates is 100.
Example
rcommand
This command provides access to a cluster Member CLI for configuration.
Syntax
rcommand id <member-id>
- member-id - The ID number to assign to the Member switch.
(Range: 1-36)
Command Mode
Privileged Exec
Console(config)#cluster member mac-address 00-12-34-56-78-9a id 5
Console(config)#

SMC Networks TigerSwitch SMC6128L2 Specifications

General

Model	SMC6128L2
Port Speed	10/100/1000 Mbps
Switching Capacity	56 Gbps
MAC Address Table Size	8K
Jumbo Frame Support	Yes
Manageable	Yes
Power Supply	Internal
Power Consumption	30 W
Weight	2.5 kg
Type	Switch
Jumbo Frame Support Size	9216 bytes
Forwarding Rate	41.7 Mpps

Summary

Introduction

Key Features

Lists the main features of the switch, including authentication, port configuration, and support for various protocols.

Initial Configuration

Connecting to the Switch

Explains how to establish a connection to the switch via console port or Telnet for initial setup.

Setting an IP Address

Details configuring the switch's IP address, subnet mask, and default gateway for network management access.

Configuring the Switch

Using the Web Interface

Introduces the web-based agent for configuring switch parameters, monitoring ports, and viewing statistics.

Configuring the Secure Shell

Guides on using SSH as a secure replacement for Telnet for remote management access and authentication.

Access Control Lists

Details creating ACLs for packet filtering based on IP/MAC addresses, protocols, and ports for security.

VLAN Configuration

Explains VLANs for organizing network nodes into separate broadcast domains, enhancing security and efficiency.

Quality of Service

DHCP Snooping Commands

IP Source Guard Commands

Switch Clustering Commands

Command Line Interface (CLI)

Using the Command Line Interface

Spanning Tree Commands

Troubleshooting

Problems Accessing the Management Interface