SMC Networks TigerSwitch SMC6128L2 User Manual

C OMMAND L INE I NTERFACE
4-162
Link Aggregation Commands
Ports can be statically grouped into an aggregate link (i.e., trunk) to
increase the bandwidth of a network connection or to ensure fault
recovery. Or you can use the Link Aggregation Control Protocol (LACP)
to automatically negotiate a trunk link between this switch and another
network device. For static trunks, the switches have to comply with the
Cisco EtherChannel standard. For dynamic trunks, the switches have to
comply with LACP. This switch supports up to six trunks. For example, a
trunk consisting of two 1000 Mbps ports can support an aggregate
bandwidth of 4 Gbps when operating at full duplex.
Table 4-47 Link Aggregation Commands
Command Function Mode Page
Manual Configuration Commands
interface port-channel Configures a trunk and
enters interface
configuration mode for the
trunk
GC 4-144
channel-group Adds a port to a trunk IC (Ethernet) 4-164
Dynamic Configuration Commands
lacp Configures LACP for the
current interface
IC (Ethernet) 4-164
lacp system-priority Configures a port's LACP
system priority
IC (Ethernet) 4-167
lacp admin-key Configures a port's
administration key
IC (Ethernet) 4-168
lacp admin-key Configures a port channel’s
administration key
IC (Port Channel) 4-169
lacp port-priority Configures a port's LACP
port priority
IC (Ethernet) 4-170
Trunk Status Display Commands
show interfaces status
port-channel
Shows trunk information NE, PE 4-151
show lacp Shows LACP information PE 4-171

SMC Networks TigerSwitch SMC6128L2 Specifications

General

Brand	SMC Networks
Model	TigerSwitch SMC6128L2
Category	Switch
Language	English