S
YSTEM
M
ANAGEMENT
C
OMMANDS
4-63
Default Setting
None
Command Mode
Privileged Exec
Example
The following example shows that system logging is enabled, the message
level for flash memory is “errors” (i.e., default level 3 - 0), and the message
level for RAM is “debugging” (i.e., default level 7 - 0).
The following example displays settings for the trap function.
Console#show logging flash
Syslog logging: Enabled
History logging in FLASH: level errors
Console#show logging ram
Syslog logging: Enabled
History logging in RAM: level debugging
Console#
Table 4-19 show logging flash/ram - display description
Field Description
Syslog logging Shows if system logging has been enabled via the logging
on command.
History logging in
FLASH
The message level(s) reported based on the logging history
command.
History logging in
RAM
The message level(s) reported based on the logging history
command.
Console#show logging trap
Syslog logging: Enable
REMOTELOG status: disable
REMOTELOG facility type: local use 7
REMOTELOG level type: Debugging messages
REMOTELOG server IP address: 1.2.3.4
REMOTELOG server IP address: 0.0.0.0
REMOTELOG server IP address: 0.0.0.0
REMOTELOG server IP address: 0.0.0.0
REMOTELOG server IP address: 0.0.0.0
Console#
To Next Page
Loading...
Need help?
General
