C
OMMAND
L
INE
I
NTERFACE
4-144
interface
This command configures an interface type and enter interface
configuration mode. Use the no form to remove a trunk.
Syntax
interface interface
no interface port-channel channel-id
• interface
• ethernet unit/port
- unit - Stack unit. (Always unit 1)
- port - Port number. (Range: 1-28)
• port-channel channel-id (Range: 1-8)
• vlan vlan-id (Range: 1-4093)
Default Setting
None
Command Mode
Global Configuration
Example
To specify port 24, enter the following command:
description
This command adds a description to an interface. Use the no form to
remove the description.
Syntax
description string
no description
string - Comment or a description to help you remember what is
attached to this interface. (Range: 1-64 characters)
Default Setting
None
Console(config)#interface ethernet 1/24
Console(config-if)#
To Next Page
Loading...
Need help?
General
