EasyManuals Logo
Home>Xerox>All in One Printer>DocuColor 12/DCCS50

Xerox DocuColor 12/DCCS50 User Manual

Xerox DocuColor 12/DCCS50
1617 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1238 background imageLoading...
Page #1238 background image
1/05
8d-96
DocuColor 12/DCCS50
REP 15.2.20
Reissue
Finisher/Sorter
REP 15.2.20 Eject Paddle Motor and Drive Belt
Parts List on PL 18.19
Removal
WARNING
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the machine Power Cord.
1. Switch off the printer power and disconnect the AC Power Cord.
2. Roll the finisher away from the printer until it stops.
3. Remove the Rear Lower Cover (REP 15.3.
15).
4. Remove the Eject Clamp Sensor (REP 15.2.
17).
5. Remove the Stacker Offset Home Sensor (REP 1
5.2.18).
6. Remove the Eject Bracket Assembly (REP 15.
2.19).
7. Remove the Eject Paddle Motor and Drive Belt (Figu
re 1).
1. Disconnect P/J10
88.
2. Disconnect P/J10
55.
3. Remove the screws (2) securing the Motor Bracket to the finisher frame, and pull the
Bracket away
from the Finisher frame.
4. Free the Eject Paddle Drive Belt from the Motor Pulley, and remove the Motor
Bracket.
5.
Remove the E-ring securing the Shaft Pulley to the Motor Shaft, and remove the Pul-
ley.
6. Remove the screws (2) securing the Eject Paddl
e Motor to the Motor Bracket, and
remove the Motor.
7. Remove the Eject Paddle Motor Drive Belt from the Eject Pulley.
Figure 1 Remove the Eject Paddle Motor and Drive Belt
Replacement
1. Reinstall the Eject Paddle Motor onto the Motor Bracket, and use the screws (2) to secure
the Motor.
2. Slide the Shaft Pulley, with the lip facing away from the Motor onto the Motor Shaft. Use
the
E-ring to secure the Pulley onto the Shaft.
3. Reinstall the Motor Bracket onto the Finisher frame, by f
irst slipping the Eject Paddle Drive
Belt over the Shaft Pulley. Use the screws (2) to secure the Motor Bracket to the Finisher
frame.
4. Reconnect P
/J
1088 and P/J1055.
5. If removed, reinstall the Finisher PWB Cover and the Harness Cover.
6. Reinstall the Eject Bracket Assembly.
7. Reinstall the Stacker Offset Home Sensor.
8. Reinstall the Eject Clamp Sensor.
9. Reinstall the Rear Lower Cover.
manuals4you.commanuals4you.com

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox DocuColor 12/DCCS50 and is the answer not in the manual?

Xerox DocuColor 12/DCCS50 Specifications

General IconGeneral
BrandXerox
ModelDocuColor 12/DCCS50
CategoryAll in One Printer
LanguageEnglish

Related product manuals