1/05
2-126
DocuColor 12/DCCS50
9-379 Trickle Bottle Full RAP, 9-400 Black Toner Near
Reissue
Status Indicator RAPs
9-379 Trickle Bottle Full RAP
Trickle Bottle Full. This status code is declared when the number of copies reach a specific
count after the Trickle Toner Full Sensor has detected a full trickle bottle.
Initial Actions
• Refer to BSD 9.3 and BSD 9.15 for the following procedure.
• Check the Trickle Toner Full Sensor for dirt or foreign matter
Check that the P/J122 on t
he Trickle Toner Full Sensor, and P/J417A on the IOT Drive PWB
are firmly connected.
Procedure
The Trickle Toner Bottle is full.
YN
Enter d
C330 009-251 Trickle Bottle Sensor. Pr
ess Start. The Display is (H)
YN
Check the Trickle Toner Full Sensor for intermittent operation. If the sensor appears
t
o be good,
replace the IOT Drive PWB (PL 9.2). If the problem continues, replace
the Trickle Toner Full Sensor (PL 6.5).
+5 VDC is measured between P/J4
17A-4 and GND on the IOT Drive PWB.
YN
Replace the IOT Drive PWB (PL 9.
2).
+24 V
DC is Measured between P/J417A-1 and
P/J417A-3 on the IOT Drive PWB.
YN
Go to the +24 VDC (IOT) Wirenet and check the wires between P/
J23-1 on t
he IOT
LVPS and P/J417A-1 on the IOT Drive PWB for an open circuit. Go to the DC COM
(24 VRET) Wirenet and check the wires between P/J23-4 on the IOT LVPS and P/
J417A-3 on the IOT Drive PWB for an open circuit.
Go to Fl
ag 2 on BS
D 9.3. Check the wire for an open circuit. Check the wires between P/
J122-1 of the Trickle Toner Full Sensor and P/J417A-1 of the IOT Drive PWB and
between P/J122-3 of the Trickle Toner Full Sensor and P/J417A-3 of the IOT Drive PWB
for an open circuit. If the wires are good, replace the Trickle Toner Full Sensor (PL 6.5).
Replace the Trickle Toner Bottle (Section 6, M
achine Cons
umables).
9-400 Black Toner Near Empty RAP
Control Logic has detected that the Black dispenser is almost empty.
Initial Actions
This is a message fault only. An operator action is required
Procedure
This fault should not require any service action. If this fault causes a problem, use the 9-356
Cyan Toner Dispenser Broken RAP to troubleshoot the problem.
manuals4you.commanuals4you.com