To Next Page

To Previous Page

1/05

6-126

DocuColor 12/DCCS50

dC919 Color Balance Setup (IIT installed machine

Reissue

General Procedures

dC919 Color Balance Setup (IIT installed machine only)

Purpose

Takes a 4C copy in the Photo Mode and visually checks the Color Balance and then sets the

KYMC Color Balance NVM.

NOTE:

1. Run this function only when requested by the customer for a Color Adjustment after the

Automat

ic Gray-Scale Correction has been performed (Tool mode).

2. Before running this function the dC918 High Light Setup must have been performed prop-

erly.

NOTE: For details on dC919 Color Balance Setup, see Adjustments Section 4: ADJ 9.1.

Color Balance Setup (dC919).

dC920 Developer Unit Check

Purpose

Rotates the Rotary Developer and sets it at the desired position.

Procedure

1. Enter the Service Diagnostics Mode. Refer to Entering the Service Diagnostic Mode

using the PWS.

2. Select Dia

gnostics on the “Service Entry Screen.”

3. Select System Test

in the “Fault Diagnostics Screen”.

4. Select Develop

er Unit Check (dc920).

5. Select the Develop

er Unit to move. Select Start.

6. After checking, move the Develop

er Unit to the Home Position.

manuals4you.commanuals4you.com

Xerox DocuColor 12/DCCS50 User Manual

Questions and Answers: