FEATURES
1-14
The display shows the current setting for each
function, except the shift timing indicator light
activity function.
To adjust the brightness of the multifunction
meter displays and tachometer
1. Turn the key to “OFF”.
2. Push and hold the “SELECT” button.
3. Turn the key to “ON”, and then release the
“SELECT” button after five seconds.
4. Push the “RESET” button to select the
desired brightness level.
5. Push the “SELECT” button to confirm the
selected brightness level. The control
mode changes to the shift timing indicator
light activity function.
To set the shift timing indicator light activity
function
1. Push the “RESET” button to select one of
the following indicator light activity settings:
• The indicator light stays on when acti-
vated. (This setting is selected when the
indicator light stays on.)
• The indicator light flashes when acti-
vated. (This setting is selected when the
indicator light flashes four times per sec-
ond.)
• The indicator light is deactivated; in other
words, it does not come on or flash. (This
setting is selected when the indicator light
flashes once every two seconds.)
2. Push the “SELECT” button to confirm the
selected indicator light activity. The control
mode changes to the shift timing indicator
light activation function.
To set the shift timing indicator light activation
function
The shift timing indicator light activation func-
tion can be set between 7000 r/min and 15000
r/min. From 7000 r/min to 12000 r/min, the indi-
cator light can be set in increments of 500 r/
min. From 12000 r/min to 15000 r/min, the indi-
cator light can be set in increments of 200 r/
min.
1. Push the “RESET” button to select the
desired engine speed for activating the
indicator light.
2. Push the “SELECT” button to confirm the
selected engine speed. The control mode
changes to the shift timing indicator light
deactivation function.
To set the shift timing indicator light deactiva-
tion function
• The shift timing indicator light deactivation
function can be set between 7000 r/min and
15000 r/min. From 7000 r/min to 12000 r/
min, the indicator light can be set in incre-
ments of 500 r/min. From 12000 r/min to
15000 r/min, the indicator light can be set in
increments of 200 r/min.
• Be sure to set the deactivation function to a
higher engine speed than for the activation
function, otherwise the shift timing indicator
light remains deactivated.
1. Push the “RESET” button to select the
desired engine speed for deactivating the
indicator light.
2. Push the “SELECT” button to confirm the
selected engine speed. The control mode
changes to the shift timing indicator light
brightness function.
To adjust the shift timing indicator light bright-
ness
1. Push the “RESET” button to select the
desired indicator light brightness level.
2. Push the “SELECT” button to confirm the
selected indicator light brightness level.
The control mode changes to the throttle
opening position display.
To set the throttle opening position display
1. Push the “RESET” button to select one of
the following activity settings:
• The throttle opening segments and “R1”
are displayed.
• “R1” is displayed only.
• Neither throttle opening segments nor
“R1” are displayed.
2. Push the “SELECT” button to confirm the
selected throttle opening position display
activity. The display returns to the odome-
ter or tripmeter mode.
To Next Page
Loading...
Need help?
General
