38 ACS550-02/U2 User’s Manual
Installation
Preparing the mounting location on a cable channel
In this case there are various ways how to fix the drive onto the channel.
1. Check that there is a place for the fixing holes.
2. Check that there is space under the lead-through plate for the cables.
Preparing the mounting location on a raised floor
This method is used in cases when several drives are located in the same space
close to each other. The pedestal is constructed normally on-site.
1. Check that there is a place for the fixing holes.
2. Check that the route is free for the main cables.
Preparing the mounting location against a wall
Because of its weight it is not recommended to mount the drive on a wall but it can
be fastened on a wall for additional support.
1. Lift the drive against the wall into the mounting place.
2. Check that the cable openings through the floor are in an appropriate place.
3. Mark the bottom edges of the drive to the floor.
4. Mark the locations of the two fixing points on the wall.
To Next Page
Loading...
Need help?
General
