54 ACS550-02/U2 User’s Manual
Installation
Connecting the control cables
Connect the control cables as described below. Connect the conductors to the
appropriate terminals of the control board. Tighten the screws to secure the
connection. Use 0.4 N·m (0.3 lbf·ft) torque for both frame sizes.
Control connections
To complete the control connections, use:
• Cable recommendations in section Power factor compensation capacitors on
page 23
• Table Hardware description on page 55
• ABB Standard macro on page 102
• Complete parameter descriptions on page 128
• Embedded fieldbus: Mechanical and electrical installation – EFB on page 220.
To Next Page
Loading...
