D30 19
Central lubrication system (O)
The central lubrication system is activated
in automatic mode as soon as the drive
engine is started.
- Pumping time: 12 min
- Pause time: 2 h
It is prohibited to change the factory-set
durations of pumping and break without
consulting the technical customer service!
Changing the duration of lubrication and
breaks may be necessary when laying
mineral or cement bound material mix.
Manual start of lubrication (pumping time):
- Remove the screw cap (1).
- Keep the starting button (2) pressed for at least 2 seconds.
- Reinstall the screw cap (1).
Observe the instructions in section "Maintenance"!
To Next Page
Loading...
Need help?
General
