F10 1
F10 Maintenance
1. Notes regarding safety
Maintenance work: Maintenance work may only be carried out when the engine
is at a standstill.
Secure the paver finisher and the attachments against inadvertent starting before
beginning any maintenance work:
- Set the drive lever to the centre position and the speed preselector to zero.
- Pull out the ignition key.
- Switch off the battery main switch.
Lift and jacking up: Secure lifted machine parts (e.g. screed or hopper) against
lowering by means of mechanical supports.
Spare parts: Use only approved parts and install them according to the
specifications! If in doubt, contact the manufacturer!
Re-commissioning: Mount all protective devices before re-commissioning the
paver finisher.
Cleaning: Cleaning must not be carried out while the engine is running.
Do not use any inflammeable substances (such as petrol).
Avoid directly cleaning electrical parts and insulation material with a steam jet;
cover them up beforehand.
Working in enclosed environments: Exhaust fumes must be conducted into the
open air. Propane gas bottles must not be stored in closed rooms.
In addition to these maintenance instructions, the maintenance instructions issued
by the engine manufacturer must be adhered to under all circumstances. All
maintenance work and service intervals itemised here are binding in nature.
Information on how to maintain the optional equipment can be found in the
individual sub-sections of this chapter!
To Next Page
Loading...
Need help?
General
