E11 32
Mounting and aligning the sensors
- Insert the sensor mounting (1)
into the bracket (2).
- Align the sensor and secure with
the relevant star handle bolts.
- The sensing height can be
adjusted by loosening the star
handle bolts (3).
At the two outer sensor brackets,
brackets, the sensor can also be
mounted on the swiveling sensor
extension arm (4).
This therefore enables the two
outer sensors to be swivelled
during paving for diverse
requirements, e.g. cornering.
- By loosening the star handle bolts (5), the length of the extension arm can be
adjusted.
- The sensor bracket with extension arm can be swivelled by loosening the star
handle bolts(3).
If a sensor extension arm is swivelled to the side, it must be ensured that the
attached sensor is subsequently aligned in the direction of travel.
All assembly parts must be mounted and tightened properly to ensure safe and
precise operation of the big ski!
To Next Page
Loading...
Need help?
General
