D41 9
External starting (starting aid)
The engine can be started with the help of an external power source if the batteries
are empty and the starter no longer turns.
Suitable power sources are:
- Other vehicles with a 24V system
- Additional 24V battery
- Start device that is suitable for external starting (24V/90A).
Standard chargers or quick chargers cannot be used for external starting.
To externally start the engine:
- Switch on the ignition(11), set the drive lever (13) to the centre position and the
travel drive preselector (15) to minimum.
- Use appropriate cables to connect the external power source.
Observe the polarity! Always connect the negative cable last and disconnect it first!
It is impossible to start the vehicle, if one of the emergency stop buttons (16) / (120)
is depressed.
- Switch the ignition key to start the engine. Do not let the starter run permanently
for more than 20 seconds; allow for a break of 1 minute after every attempt!
When the engine is running:
- Disconnect the power source
To Next Page
Loading...
Need help?
General
