EasyManuals Logo
Home>Atlas Copco>Construction Equipment>Dynapac F3030C

Atlas Copco Dynapac F3030C User Manual

Atlas Copco Dynapac F3030C
300 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #274 background imageLoading...
Page #274 background image
F81 2
Maintenance of batteries
1. Do not over discharge the battery, and recharge it timely after discharging.
2. Take off the battery from the paver finisher or disconnect the cathode of the
battery before stopping using the paver for a long time.
Fully charge the battery before stopping using it, keep a frequent check for its
voltage and recharge it when the voltage is lower than 12.6V.
3. It is forbidden to check the voltage by short-circuiting the battery.
4. Always check and well connect the cables, keep the terminal surfaces clean to
guarantee a good connection.
5. The bleeder can not be blocked. The battery shall be prevented
from freezing in winter; otherwise explosion could happen due to an increased
internal pressure of the battery.
Fuses and relays
Fuses in control box

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Atlas Copco Dynapac F3030C and is the answer not in the manual?

Atlas Copco Dynapac F3030C Specifications

General IconGeneral
BrandAtlas Copco
ModelDynapac F3030C
CategoryConstruction Equipment
LanguageEnglish

Related product manuals