EasyManuals Logo
Home>AudioCodes>Gateway>MediaPack MP-118

AudioCodes MediaPack MP-118 User Manual

AudioCodes MediaPack MP-118
584 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #144 background imageLoading...
Page #144 background image
User's Manual 144 Document #: LTRT-65422
MP-11x & MP-124
2. Configure the following parameters:
• 'Voice Volume' (VoiceVolume) - Defines the voice gain control (in decibels) for IP-
to-Tel
• 'Input Gain' (InputGain) - Defines the PCM input gain control (in decibels) for Tel-
to-IP
3. Click Submit to apply your settings.
13.1.2 Silence Suppression (Compression)
Silence suppression (compression) is a method for conserving bandwidth on VoIP calls by
not sending packets when silence is detected. The device uses its VAD feature to detect
periods of silence in the voice channel during an established call. When silence is
detected, it stops sending packets in the channel.
The procedure below describes how to enable silence suppression using the Web
interface.
 To enable silence suppression using the Web interface:
1. Open the Voice Settings page (Configuration tab > VoIP menu > Media submenu >
Voice Settings).
Figure 13-2: Enabling Silence Suppression in Voice Settings Page
2. Set the 'Silence Suppression' (EnableSilenceCompression) field to Enable.
3. Click Submit to apply your changes.
13.1.3 Echo Cancellation
The device supports adaptive linear (line) echo cancellation according to G.168-2002.
Echo cancellation is a mechanism that removes echo from the voice channel. Echoes are
reflections of the transmitted signal.
In this line echo, echoes are generated when two-wire telephone circuits (carrying both
transmitted and received signals on the same wire pair) are converted to a four-wire circuit.
Echoes are reflections of the transmitted signal, which result from impedance mismatch in
the hybrid (bi-directional 2-wire to 4-wire converting device).
An estimated echo signal is built by feeding the decoder output signal to an RLS-like
adaptive filter, which adapts itself to the characteristics of the echo path. The ‘estimated
echo signal’ (the output of this filter) is then subtracted from the input signal (which is the
sum of the desired input signal and the undesired echo) to provide a clean signal. To
suppress the remaining residual echo, a Non Linear Processor (NLP) is used, as well as a
double-talk (two people speak at the same time) detector that prevents false adaptation
during near-end speech.

Table of Contents

Other manuals for AudioCodes MediaPack MP-118

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes MediaPack MP-118 and is the answer not in the manual?

AudioCodes MediaPack MP-118 Specifications

General IconGeneral
BrandAudioCodes
ModelMediaPack MP-118
CategoryGateway
LanguageEnglish

Related product manuals