32.4.7 Configuration using AudioCodes EMS
AudioCodes EMS server functions as a core-network provisioning server. The device's
SNMP Manager should be configured with the IP address of the EMS server, using one of
the methods detailed in the previous sections. As soon as a registered device contacts the
EMS server through SNMP, the EMS server handles all required configuration
automatically, upgrading software as needed. This alternative method doesn't require
additional servers at the customer premises, and is NAT-safe.
32.5 Loading Files Securely (Disabling TFTP)
The TFTP protocol is not considered secure and some network operators block it using a
firewall. It is possible to disable TFTP completely, using the ini file parameter
EnableSecureStartup (set to 1). This way, secure protocols such as HTTPS may be used
to fetch the device configuration.
 To download the ini file to the device using HTTPS instead of TFTP:
1. Prepare the device's configuration file on an HTTPS server and obtain a URL to the
file (e.g., https://192.168.100.53/gateways.ini).
2. Enable DHCP, if necessary.
3. Enable SSH and connect to it.
4. In the CLI, use the ini file parameters IniFileURL (for defining the URL of the
configuration file) and EnableSecureStartup (for disabling TFTP), and then restart the
device with the new configuration:
/conf/scp IniFileURL https://192.168.100.53/gateways.ini
/conf/scp EnableSecureStartup 1
/conf/sar bootp
Note: Once Secure Startup has been enabled, it can only be disabled by setting
EnableSecureStartup to 0 using the CLI. Loading a new ini
To Next Page
Loading...
Need help?
General
