4.1.8.5 Loading a Scenario to the Device
The procedure below describes how to load a previously saved Scenario file (data file)
from your computer to the device. For saving a Scenario, see 'Saving a Scenario to a PC'
on page 54.
 To load a Scenario to the device:
1. On the Navigation bar, click the Scenarios tab; the Scenario appears in the
Navigation tree.
2. Click the Get/Send Scenario File button, located at the bottom of the Navigation tree;
the Scenario File page appears.
3. Click the Browse button, and then navigate to the Scenario file saved on your
computer.
4. Click the Send File button.
Notes:
• You can only load a Scenario file to a device that has the same hardware
configuration as the device on which it was created.
• The loaded Scenario replaces any existing Scenario.
• You can also load a Scenario file using BootP, by loading an ini file that
contains the ini file parameter ScenarioFileName (see Web and Telnet
Parameters on page 431). The Scenario file must be located in the same
folder as the ini file. For information on using AudioCodes AcBootP utility,
refer to AcBootP Utility User's Guide.
4.1.8.6 Deleting a Scenario
You can delete the Scenario, as described in the procedure below.
 To delete the Scenario:
1. On the Navigation bar, click the Scenarios tab; a message box appears, requesting
you to confirm:
2. Click OK; the Scenario mode appears in the Navigation tree.
3. Click the Delete Scenario File button; a message box appears requesting
confirmation for deletion.
Figure 4-20: Message Box for Confirming Scenario Deletion
To Next Page
Loading...
Need help?
General
