43 Configuration Parameters Reference
The device's configuration parameters, default values, and their descriptions are
documented in this section.
Note: Parameters and values enclosed in square brackets [...] represent the ini file
parameters and their enumeration values.
43.1 Networking Parameters
This subsection describes the device's networking parameters.
43.1.1 Ethernet Parameters
The Ethernet parameters are described in the table below.
Table 43-1: Ethernet Parameters
Parameter Description
EMS: Physical Configuration
[EthernetPhyConfiguration]
Defines the Ethernet connection mode type.
 [0] = 10Base-T half-duplex (Not applicable)
 [1] = 10Base-T full-duplex
 [2] = 100Base-TX half-duplex
 [3] = 100Base-TX full-duplex
 [4] = (Default) Auto-negotiate
Note: For this parameter to take effect, a device reset is required.
43.1.2 Multiple VoIP Network Interfaces and VLAN Parameters
The IP network interfaces and VLAN parameters are described in the table below.
Table 43-2: IP Network Interfaces and VLAN Parameters
Parameter Description
Multiple Interface Table
Web: Multiple Interface Table
EMS: IP Interface Settings
[InterfaceTable]
This table parameter configures the Multiple Interface table. The
format of this parameter is as follows:
[InterfaceTable]
FORMAT InterfaceTable_Index =
InterfaceTable_ApplicationTypes,
InterfaceTable_InterfaceMode, InterfaceTable_IPAddress,
InterfaceTable_PrefixLength, InterfaceTable_Gateway,
InterfaceTable_VlanID, InterfaceTable_InterfaceName,
InterfaceTable_PrimaryDNSServerIPAddress,
InterfaceTable_SecondaryDNSServerIPAddress,
InterfaceTable_UnderlyingInterface;
[\InterfaceTable]
To Next Page
Loading...
Need help?
General
