AudioCodes MediaPack MP-118 User Manual

User's Manual 576 Document #: LTRT-65422
MP-11x & MP-124
43.13 Auxiliary and Configuration File Name Parameters
The configuration files (i.e., auxiliary files) can be loaded to the device using the Web
interface or a TFTP session. For loading these files using the ini file, you need to configure
these files in the ini file and configured whether they must be stored in the non-volatile
memory. The table below lists the ini file parameters associated with these auxiliary files.
For more information on the auxiliary files, see 'Loading Auxiliary Files' on page 327.
Table 43-63: Auxiliary and Configuration File Parameters
Parameter Description
General Parameters
[SetDefaultOnIniFileProcess]
Determines if all the device's parameters are set to their defaults
before processing the updated ini file.
 [0] = Disable - parameters not included in the downloaded ini file
are not returned to default settings (i.e., retain their current
settings).
 [1] = Enable (default).
Note: This parameter is applicable only for automatic HTTP update
or Web ini file upload (not applicable if the ini file is loaded using
BootP).
[SaveConfiguration]
Determines if the device's configuration (parameters and files) is
saved to flash (non-volatile memory).
 [0] = Configuration isn't saved to flash memory.
 [1] = (Default) Configuration is saved to flash memory.
Auxiliary and Configuration File Name Parameters
Web/EMS
: Call Progress Tones
File
[CallProgressTonesFilename]
Defines the name of the file containing the Call Progress Tones
definitions. For more information on how to create and load this file,
refer to DConvert Utility User's Guide.
Note: For this parameter to take effect, a device reset is required.
Web/EMS: Prerecorded Tones
File
[PrerecordedTonesFileName]
Defines the name (and path) of the file containing the Prerecorded
Tones.
Note: For this parameter to take effect, a device reset is required.
Web: Dial Plan File
EMS: Dial Plan File Name
[DialPlanFileName]
Defines the name (and path) of the Dial Plan file. This file should be
created using AudioCodes DConvert utility (refer to DConvert Utility
User's Guide).
[UserInfoFileName]
Defines the name (and path) of the file containing the User
Information data.

AudioCodes MediaPack MP-118 Specifications

General

Brand	AudioCodes
Model	MediaPack MP-118
Category	Gateway
Language	English