Version 6.6 229 MP-11x & MP-124
User's Manual 22. Routing
destinations associated with this Forking Group and alternative
routing is enabled, the device forks the call to the Forking Group of
the next matched routing rules as long as the Forking Group is
defined with a higher number than the previous Forking Group.
For example:
 Table index entries 1 and 2 are defined with Forking Group "1",
and index entries 3 and 4 with Forking Group "2": The device first
sends the call according to index entries 1 and 2, and if
unavailable and alternative routing is enabled, sends the call
according to index entries 3 and 4.
 Table index entry 1 is defined with Forking Group "2", and index
entries 2, 3, and 4 with Forking Group "1": The device sends the
call according to index entry 1 only and ignores the other index
entries even if
the destination is unavailable and alternative routing
is enabled. This is because the subsequent index entries are
defined with a Forking Group number that is lower than that of
index entry 1.
 Table index entry 1 is defined with Forking Group "1", index entry
2 with Forking Group "2", and index entries 3 and 4 with Forking
Group "1": The device first sends the call according to index
entries 1, 3, and 4 (all belonging to Forking Group "1"), and if the
destination is unavailable and alternative routing is enabled, the
device sends the call according to index entry 2.
 Table index entry 1 is defined with Forking Group "1", index entry
2 with Forking Group "3", index entry 3 with Forking Group "2",
and index entry 4 with Forking Group "1": The device first sends
the call according to index entries 1 and 4 (all belonging to Forking
Group "1"), and if the destination is unavailable and alternative
routing is enabled, the device sends the call according to index
entry 2 (Forking Group "3"). Even if index entry 2 is unavailable
and alternative routing is enabled, the device ignores index entry 3
because it belongs to a Forking Group that is lower than index
entry 2.
Notes:
 To enable Tel-to-IP call forking, set the 'Tel2IP Call Forking Mode'
(Tel2IPCallForkingMode) parameter to Enable.
 When the UseDifferentRTPportAfterHold parameter is enabled,
every forked call is sent with a different RTP port. Thus, ensure
that the device has available RTP ports for these forked calls.
To Next Page
Loading...
Need help?
General
