12.7
Dismantling/reassembling
alternator
•
Take out the cover retaining screws (1).
•
Release clips (2) and remove the cover.
•
Remove voltage regulator (3).
•
Remove the Poly-V belt pulley.
•
Install by following the above work instructions in
the reverse order.
X Tightening torque:
Belt pulley at alternator................................. 50 Nm
Checking alternator
•
Test with BMW MoDiTeC.
Checking armature for short to ground
(earth)
•
Test with BMW MoDiTeC.
1
2
3
RS120050
To Next Page
Loading...
Need help?
General
