00.11
Key to maintenance intervals
– BMW Inspection
1000 km/600 miles I
– BMW Service II
– BMW Inspection III
– BMW Annual Service IV
Reading out MoDiTeC fault memory
(Inspections I, II, III and IV)
•
Remove the left air cleaner trim panel.
•
Connect MoDiTeC to diagnostic plug.
•
Read out the fault memory.
•
Perform any repair work indicated.
Checking throttle cable play,
adjusting if necessary
(Inspections I and III)
•
Check throttle cable for free movement and free-
dom from abrasion or kinking; renew if neces-
sary.
•
With the steering turned to various angles, open
the throttle twistgrip fully and allow it to close
again.
•
When released, the twistgrip must return to the
closed position by itself.
•
Pull back the protective cap.
•
Preset throttle cable play with the engine cold to
1.5 mm (0.06 in).
•
Warm the engine up to its regular operating tem-
perature.
•
Adjust throttle cable play to 0.5 mm (0.02 in).
Adjusting value:
Initial throttle cable play setting
(engine cold) ................................. 1.5 mm (0.06 in)
Throttle cable play (engine warm).. 0.5 mm (0.02 in)
C000010
To Next Page
Loading...
Need help?
General
