36.6
Removing and installing wheel
bearings
•
Carefully lever out the shaft sealing ring with a
screwdriver.
•
Remove the circlip.
•
Clamp a drift, BMW No. 36 5 513, into the vice
and place the wheel on it with the wide bearing
in contact.
•
Place a spacing ring, BMW No. 31 4 800, be-
tween the wheel hub at the right and the claws of
the internal puller.
•
Heat bearing seat to 80 °C (176 °F).
•
Pull out the wheel bearing with counter-support
22/1, BMW No. 00 8 572, and internal puller
21/4, BMW No. 00 8 573.
•
Press out spacing bushing (1) and wheel bear-
ing (2) with drift, BMW No. 36 5 530.
•
Degrease bearing seats.
•
Heat bearing seat to 80 °C (176 °F).
•
First insert wide bearing using drift,
BMW No. 36 5 512, and handle,
BMW No. 00 5 500.
C360031
00 8 572
RS360022
00 8 573
31 4 800
36 5 513
36 5 530
RS360023
2
1
RS360026
00 5 500
36 5 512
To Next Page
Loading...
Need help?
General
