00.25
Checking tightness of rear wheel
studs
(Inspection I)
•
Tighten the rear wheel studs with a torque
wrench.
X Tightening torque:
Rear wheel studs ....................................... 105 Nm
Checking rear wheel bearing play by
tilting wheel
(Inspection III)
•
Tilt the rear wheel to and fro across its axle.
•
If play is detected, fit new shims to rear wheel
drive or renew bearings.
Checking swinging arm bearings,
adjusting if necessary
(Inspections I and III)
•
Grip rear tyre and try to move it sideways, brac-
ing against the frame.
Greasing the side (prop) stand pivot
(Inspections I, II and III)
•
Check free movement of side (prop) stand and
grease if necessary.
•
Grease pivot point (arrow).
Lubricant:
For side (prop) stand pivot........... Shell Retinax EP2
Checking function of side (prop)
stand contact switch
(Inspections I, II, III and IV)
•
Place the motorcycle on the auxiliary stand,
BMWNo.001550.
•
Select a gear and switch on the ignition.
•
Slowly extend the side (prop) stand and watch
the neutral indicator light.
L Note:
As the stand is extended, the neutral indicator light
should come on briefly.
C000200
To Next Page
Loading...
Need help?
General
