00.18
Checking brake system for correct
operation and freedom from leaks;
repairing/renewing if necessary
(Inspection III)
•
Checking brake system for leaks.
Checking brake fluid level
L Note:
The brake fluid volume (between MIN and MAX) is
sufficient for the complete range of pad wear from
new to the wear limit.
It is not normally necessary to add fluid to compen-
sate for pad wear.
If the level drops below the minimum mark, this indi-
cates some other fault.
(Inspections I, II and III)
Front brake
•
Make sure that the specified setting (distance
between handlebar and fuel tank 30-50 mm/
1.2-2 in) is correct.
•
Check with the motorcycle on its side (prop)
stand.
•
Turn the handlebar fully to the left.
•
The brake fluid must not drop below the mini-
mum level 2 mm (0.08 in) below the ring mark (ar-
row).
Brake fluid grade.........................................DOT 4
Rear brake
•
Position the motorcycle horizontally with auxiliary
stand, BMW No. 00 1 550.
•
Brake fluid must not drop below the minimum
level (arrow).
Brake fluid grade .........................................DOT 4
CUB0110
C000090
To Next Page
Loading...
Need help?
General
