Syntax
activate storageArray firmware
Parameters
None
Add Member To Consistency Group
Description
This command adds a new base virtual disk as a member to a an existing consistency group. You can
specify an existing repository virtual disk for the new consistency group member, or create a new
repository virtual disk. When you create a new repository virtual disk, you identify an existing disk group
or an existing disk pool where you want the repository virtual disk.
Syntax For Use With An Existing Repository Virtual Disk
set consistencyGroup ["consistencyGroupName"]
addCGMemberVolume="baseVirtualDiskName"
repositoryVirtualDisk="repositoryName"
Syntax For Use When Creating A New Repository Virtual Disk In A Disk Group
set consistencyGroup ["consistencyGroupName"]
addCGMemberVolume="
baseVirtualDiskName"
repositoryVirtualDisk=("diskGroupName" capacity=capacityValue(KB|MB|GB|TB|
bytes))
Syntax For Use When Creating A New Repository Virtual Disk In A Disk Pool
set consistencyGroup ["consistencyGroupName"]
addCGMemberVolume="baseVirtualDiskName"
repositoryVirtualDisk=("
diskPoolName" capacity=capacityValue(KB|MB|GB|TB|bytes))
Parameters
Parameter Description
consistencyGroup
The name of the consistency group to which you
want to add a new member virtual disk. The new
member virtual disk is the base virtual disk for
snapshot operations. Enclose the consistency group
name in double quotation marks (" ") inside square
brackets ([ ]).
addCGMemberVolume
The name of a base virtual disk that you want to add.
Enclose the virtual disk name in square brackets ([ ]).
If the virtual disk name has special characters, you
also must enclose the member name in double
quotation marks (" ").
136
To Next Page
Loading...
Need help?
General
