expansion enclosure 1 in the first position, expansion enclosure 50 in the third position, and expansion
enclosure 12 in the fourth position.
NOTE: You must include all of the enclosures in the storage array in the list defined by the
enclosurePositions parameter. If the number of enclosures in the list does not match the total
number of enclosures in the storage array, an error message is shown.
Set Storage Array ICMP Response
Description
This command returns the default values for negotiable settings for sessions and connections, which
represent the starting point for the storage array for negotiations.
Syntax
set storageArray icmpPingResponse=(TRUE | FALSE)
Parameter
Parameter Description
icmpPingResponse
This parameter turns on or turns off Echo Request
messages. Set the parameter to TRUE to turn on
Echo Request messages. Set the parameter to
FALSE to turn off Echo Request messages.
Set Storage Array iSNS Server IPv4 Address
Description
This command sets the configuration method and address for an IPv4 Internet Storage Name Service
(iSNS).
Syntax
set storageArray isnsIPv4ConfigurationMethod=[static | dhcp]
isnsIPv4Address=ipAddress
Parameter
Parameter Description
isnsIPv4Address
The IP address that you want to use for the iSNS
server. Use this parameter with the static value for
IPv4 configurations. If you choose to have a DHCP
server set the IP address for an IPv4 Internet iSNS
server, you must set the isnsIPv4Address
parameter to 0.0.0.0.
305
To Next Page
Loading...
Need help?
General
