Parameter Description
• NEWEST - Use this option when you want to
show the latest snapshot image created in the
snapshot group.
• OLDEST - Use this option when you want to
show the earliest snapshot image created in the
snapshot group.
Enclose the snapshot image name in double
quotation marks (" ") inside square brackets ([ ]).
Notes
The name of a snapshot image has two parts separated by a colon (:):
• The identifier of the snapshot group
• The identifier of the snapshot image
For example, if you want to restart a rollback operation for snapshot image 12345 in a snapshot group
that has the name snapgroup1, you would use this command:
resume snapImage ["snapgroup1:12345"] rollback;
Resume Snapshot (Legacy) Rollback
Description
NOTE: With firmware version 7.83 the order of the terms in the syntax is changed to be consistent
with other commands. Replace the deprecated command syntax with the new command syntax.
This command resumes a rollback operation that has entered a paused state. A rollback operation can
enter a paused state due to processing errors, which triggers a Needs Attention condition for the storage
array.
If the rollback operation cannot be resumed, the selected snapshot (legacy) virtual disk reverts to a
paused state, and the Needs Attention condition is displayed.
Syntax
Deprecated
resume rollback virtualDisk [snapshotVirtualDiskName]
New
resume virtualDisk [snapshotVirtualDiskName] rollback
Parameter
Parameter Description
virtualDisk
Specifies the name of the snapshot (legacy) virtual
disk for which you want to resume a rollback
operation. Enclose the snapshot (legacy) virtual
disk name in square brackets ([ ]). If the snapshot
250
To Next Page
Loading...
Need help?
General
