Command Syntax Description
diagnose object {statement
‑
data} Runs a test and displays the results.
disable object {statement
‑
data} Prevents a feature from operating.
download object {statement
‑
data} Transfers data to the storage array or hardware
associated with the storage array.
enable object {statement
‑
data} Allows a feature to operate.
recopy object {statement
‑
data} Restarts a virtual disk copy operation by using an
existing virtual disk copy pair. You can change
attributes before the operation is restarted.
recover object {statement
‑
data} Re-creates an object from saved configuration
data and the statement attributes (similar to the
create command).
recreate object {statement
‑
data} Restarts a snapshot operation using an existing
snapshot virtual disk. You can change attributes
before the operation is restarted.
remove object {statement
‑
data} Removes a relationship from between objects.
repair object {statement
‑
data} Repairs errors found by the check command.
reset object {statement
‑
data} Returns the hardware or object to an initial state.
resume object Starts a suspended operation. The operation
begins where it left off when suspended.
revive object Forces the object from the Failed to the Optimal
state. Use only as part of an error recovery
procedure.
save object {statement
‑
data} Writes information about the object to a file.
set object {statement
‑
data} Changes object attributes. All changes are
completed when the command returns.
show object {statement
‑
data} Displays information about the object.
start object {statement
‑
data} Starts an asynchronous operation. You can stop
some operations after they have started. You can
query the progress of some operations.
stop object {statement
‑
data} Stops an asynchronous operation.
suspend object {statement
‑
data} Suspends an operation. You can then restart the
suspended operation, and it continues from the
point at which it was suspended.
Recurring Syntax Elements
Recurring syntax elements are a general category of variables and parameters you can use in one or
more script commands. The recurring syntax is used in the general definitions of the script commands
that are listed in Script Commands. The following table lists the recurring syntax and the syntax values
that you can use with the syntax.
30
To Next Page
Loading...
Need help?
General
