Dell PowerVault User Manual

Parameter Description
ID values are 0 to 31. You must put brackets ([ ])
around the enclosure ID value and slot ID value.
Start Physical Disk Reconstruction
Description
This command starts reconstructing a physical disk.
Syntax
start physicalDisk [enclosureID,slotID] reconstruct
Parameters
Parameter Description
physicalDisk
Identifies the enclosure and slot where the physical
disk resides. Enclosure ID values are 0 to 99. Slot
ID values are 0 to 31. You must put brackets ([ ])
around the enclosure ID value and slot ID value.
Start Remote Replication Synchronization
Description
This command starts Remote Replication synchronization.
Syntax
start asyncRemoteReplicationGroup ["asyncRemoteReplicationGroupName"]
synchronize [deleteRecoveryPointIfNecessary]
Parameter
Parameter Description
asyncRemoteReplicationGroup The name of the remote replication group for
which you want to start synchronization. Enclose
the remote replication group name in double
quotation marks (" ") inside square brackets ([ ]").
deleteRecoveryPointIfNecessary The parameter to delete the recovery point if the
recoverable synchronization data has exceeded
time threshold for recovery. Recovery point age is
measured from the time the data was frozen on
the primary storage array.
362

Dell PowerVault Specifications

General

RAID Levels	0, 1, 5, 6, 10, 50, 60
RAID Support	Yes
Drive Type	SAS, SSD
Interface	SAS, Fibre Channel, iSCSI
Category	Storage
Connectivity	Ethernet, Fibre Channel
Scalability	Yes
Operating System Compatibility	Windows, Linux, VMware
Management Software	PowerVault Manager, OpenManage