Dell PowerVault User Manual

Syntax
show remoteReplication candidates primary= ”virtualDiskName”
remoteStorageArrayName=
storageArrayName
Parameters
Parameter Description
primary
The name of the local virtual disk that you want for
the primary virtual disk in the remote-replicated
pair. Enclose the primary virtual disk name in
double quotation marks (“ ”).
remoteStorageArrayName
The remote storage array that contains possible
virtual disks for a secondary virtual disk. If the
remote storage array name has special characters,
it must be enclosed in double quotation marks (“ ”).
Show Remote Replication Virtual Disk Synchronization
Progress
NOTE: This command valid only with Fibre Channel storage arrays.
Description
This command returns the progress of data synchronization between the primary virtual disk and the
secondary virtual disk in a Remote Replication configuration. This command shows the progress as a
percentage of data synchronization that has been completed.
Syntax
show remoteReplication (localVirtualDisk
[“
virtualDiskName”] |
localVirtualDisks [“virtualDiskName1” ...
“virtualDiskNameN”])
Parameters
Parameter Description
localVirtualDisk or localVirtualDisks
The name of the primary virtual disk of the remote
replication pair for which you want to check
synchronization progress. Enclose the primary
virtual disk name in double quotation marks (“ ”)
inside square brackets ([ ]).
333

Dell PowerVault Specifications

General

RAID Levels	0, 1, 5, 6, 10, 50, 60
RAID Support	Yes
Drive Type	SAS, SSD
Interface	SAS, Fibre Channel, iSCSI
Category	Storage
Connectivity	Ethernet, Fibre Channel
Scalability	Yes
Operating System Compatibility	Windows, Linux, VMware
Management Software	PowerVault Manager, OpenManage