Dell PowerVault User Manual

Syntax
delete (allVirtualDisks | virtualDisk [virtualDiskName]
|virtualDisks [
virtualDiskName1... virtualDiskNameN])
removeDiskGroup=(TRUE | FALSE)
Parameters
Parameter Description
allVirtualDisks
Deletes all virtual disks in a storage array.
NOTE: Using the allVirtualDisks
parameter deletes virtual disks until all are
removed or until an error is encountered. If an
error is encountered, this command does not
attempt to delete the remaining virtual disks.
virtualDisk or virtualDisks
Name of the virtual disk to delete. You can enter
more than one virtual disk name. You must put
brackets ([ ]) around the virtual disk name. If the
virtual disk name has special characters, you must
also put quotation marks (" ") around the virtual
disk name.
removeDiskGroup
Deleting the last virtual disk in a disk group does
not delete the disk group. You can have a
standalone disk group (minus any virtual disks). To
remove the standalone disk group, set this
parameter to TRUE. To keep standalone disk
groups intact, set this parameter to FALSE.
schedule
Deletes only the schedule.
Delete Virtual Disk On A Disk Pool
Description
This command deletes either normal or thin virtual disks on a disk pool.
CAUTION: All of the data in the virtual disk is lost as soon as you run this command.
Syntax
delete (allVirtualDisks |
virtualDisk [virtualDiskName] |
virtualDisks [virtualDiskName1 ... virtualDiskNameN] | allVirtual disks)
[removeDiskGroup=(TRUE | FALSE)
retainRepositoryMembers=(TRUE | FALSE)]
force=(TRUE | FALSE)
schedule
retainRepositoryMembers=(TRUE | FALSE)]
210

Dell PowerVault Specifications

General

RAID Levels	0, 1, 5, 6, 10, 50, 60
RAID Support	Yes
Drive Type	SAS, SSD
Interface	SAS, Fibre Channel, iSCSI
Category	Storage
Connectivity	Ethernet, Fibre Channel
Scalability	Yes
Operating System Compatibility	Windows, Linux, VMware
Management Software	PowerVault Manager, OpenManage