Parameter Description
path. The connectivity test sends an inter-RAID
controller module message between the
storage arrays, and then validates that the
corresponding remote replication group on the
remote storage array exists. It also validates that
the virtual disk members of the remote
replication group on the remote system match
the virtual disk members of the remote
replication group on the local system.
• Latency—Sends a SCSI test unit command to
each virtual disk on the remote storage array
associated with the remote replication group to
test the minimum, average, and maximum
latency.
• Bandwidth—Sends two inter-RAID controller
module messages to the remote storage array
to test the minimum, average, and maximum
bandwidth as well as the negotiated link speed
of the port on the RAID controller module
performing the test.
• Port connections—Shows the port that is
being used for replicating on the local storage
array and the port that is receiving the
replicated data on the remote storage array.
Validate Storage Array Security Key
Description
This command validates the security key for a storage array that has self-encrypting disk physical disks to
make sure that the security key is not corrupt.
Syntax
validate storageArray securityKey
file="fileName"
passPhrase="passPhraseString"
Parameters
Parameter Description
file
The file path and the file name to which you want
to save the security key. For example,
file="C:\Program Files\CLI\sup\seckey.slk"
NOTE: You must add a file extension of .slk to
the end of the file name.
passPhrase
A character string that encrypts the security key so
that you can store the security key in an external
file.
386
To Next Page
Loading...
Need help?
General
