Syntax
show (allVirtualDisks | virtualDisk [virtualDiskName]
|
virtualDisks [
virtualDiskName1... virtualDiskNameN] reservations
Parameters
Parameter Description
allVirtualDisks
Returns reservation information about all virtual
disks in the storage array.
virtualDisk or virtualDisks
Name of the specific virtual disk for which you are
retrieving reservation information. You can enter
more than one virtual disk name. You must put
brackets ([ ]) around the virtual disk name. If the
virtual disk name has special characters, you must
also put quotation marks (" ") around the virtual
disk name.
Start Configuration Database Diagnostic
Description
This command starts a diagnostic test to validate the configuration database in the controller firmware.
Syntax
start storageArray configDbDiagnostic
Parameters
None.
Notes
Upon completion of the diagnostic test, the controller firmware returns one of these results:
• Diagnosis completed without errors. No ZIP file created.
• Diagnosis completed with errors. Refer to the ZIP file created at:
...\Install_dir\data\FirmwareUpgradeReports\timestamp_buildNo.zip
If the diagnostic test detects an inconsistency in the configuration database, the controller firmware
performs these actions:
• Returns a description of the inconsistency.
• Saves a ZIP file containing raw binary data.
The controller firmware saves the ZIP file to this location:
...\Install_dir\data\FirmwareUpgradeReports\timestamp_buildNo.zip
The binary data can be used to help determine the cause of the problem, or the file containing the binary
data can be sent to a Customer and Technical Support representative.
354
To Next Page
Loading...
Need help?
General
