Dell PowerVault User Manual

Parameter Description
operation at the expense of system performance.
Valid values are highest, high, medium, low, or
lowest. A value of high indicates that the rollback
operation is prioritized over all other host I/O. A
value of
lowest indicates that the rollback
operation should be performed with minimal
impact to host I/O.
Notes
You can use any combination of alphanumeric characters, underscore (_), hyphen (-), and pound (#) for
the names. Names can have a maximum of 30 characters.
When you use this command, you can specify one or more of the parameters. You do not, however,
need to use all of the parameters.
Set Snapshot Group Media Scan
Description
This command runs a media scan on a snapshot group.
Syntax
set snapGroup ["snapGroupName"]
mediaScanEnabled=(TRUE | FALSE)
consistencyCheckEnabled=(TRUE | FALSE)
Parameters
Parameter Description
snapGroup
The alphanumeric identifier (including - and _) of
the snapshot group on which you want to run a
media scan. Enclose the snapshot group name in
double quotation marks (" ") inside of square
brackets ([ ]).
mediaScanEnabled
The setting to turn on or turn off media scan for
the virtual disk. To turn on media scan, set this
parameter to TRUE. To turn off media scan, set this
parameter to FALSE. (If media scan is disabled at
the storage array level, this parameter has no
effect.)
consistencyCheckEnabled
The setting to turn on or turn off consistency
checking during a media scan. To turn on
consistency checking, set this parameter to TRUE.
To turn off consistency checking, set this
parameter to FALSE.
294

Dell PowerVault Specifications

General

RAID Levels	0, 1, 5, 6, 10, 50, 60
RAID Support	Yes
Drive Type	SAS, SSD
Interface	SAS, Fibre Channel, iSCSI
Category	Storage
Connectivity	Ethernet, Fibre Channel
Scalability	Yes
Operating System Compatibility	Windows, Linux, VMware
Management Software	PowerVault Manager, OpenManage