Dell PowerVault User Manual

Set Host Channel
Description
This command defines the loop ID for the host channel.
Syntax
set hostChannel [hostChannelNumber]
preferredID=portID
Parameters
Parameter Description
hostChannel
The identifier number of the host channel for
which you want to set the loop ID.
The host channel identifier number is constructed
by combining the controller number and the host
channel number. Enclose the host channel
identifier number in square brackets ([ ]). Separate
the controller number from the host channel
number with a comma.
For example, the identifier number for host
channel 2 on controller 0 would be [0,2].
preferredID
The port identifier for the specified host port. Port
ID values are 0 to 127.
Set Host Group
Description
This command renames a host group.
Syntax
set hostGroup [hostGroupName]
userLabel="
newHostGroupName"
Parameters
Parameter Description
hostGroup
Name of the host group to rename. You must put
brackets ([ ]) around the host group name. If the
host group name has special characters, you must
also put quotation marks (" ") around the host
group name.
userLabel
New name for the host group. You must put
quotation marks (" ") around the host group name.
278

Dell PowerVault Specifications

General

RAID Levels	0, 1, 5, 6, 10, 50, 60
RAID Support	Yes
Drive Type	SAS, SSD
Interface	SAS, Fibre Channel, iSCSI
Category	Storage
Connectivity	Ethernet, Fibre Channel
Scalability	Yes
Operating System Compatibility	Windows, Linux, VMware
Management Software	PowerVault Manager, OpenManage