NOTE: This command can be entered without defining any arguments, i.e. show iscsiSessions.
When the command is entered without arguments, the information displayed is for all active iSCSI
sessions. To limit the information displayed, enter a specific iSCSI initiator or a specific iSCSI target.
The command then displays only information about that particular iSCSI initiator or iSCSI target
session.
Show Disk Group
Description
This command returns the following information about a disk group:
• Status (online or offline)
• Physical disk type (SAS)
• Enclosure loss protection (yes or no)
• Current owner (RAID controller module 0 or RAID controller module 1)
• Associated virtual disks and free capacity
• Associated physical disks
NOTE: You can use the free capacity area value when you create a virtual disk based on the free
capacity of a disk group. For a description of how to use the free capacity value, see the
create
virtualDisk
command on Create RAID Virtual Disk (Free Capacity Base Select).
Syntax
show diskGroup [diskGroupNumber]
Parameter
Parameter Description
diskGroup
Number of the disk group for which to display
information. You must put brackets ([ ]) around the
disk group number.
Show Disk Group Export Dependencies
Description
This command shows a list of dependencies for the physical disks in a disk group that you want to move
from one storage array to a second storage array.
Syntax
show diskGroup [diskGroupName] exportDependencies
324
To Next Page
Loading...
Need help?
General
