Parameter Description
• The old repository virtual disk will be deleted by
default.
diskPoolUserLabel
Use this parameter to allocate a new repository
virtual disk with the specified capacity.
retainRepositoryMember
If this parameter is set to TRUE, the old repository
is retained. By default, the old repository is deleted.
This parameter is ignored if the existing repository
is reused.
Remove Incomplete Remote Replicated Pair From
Remote Replication Group
Description
This command removes an orphaned replicated pair virtual disk on the storage array. An orphaned
replicated pair virtual disk exists when a member virtual disk in a remote replication group has been
removed on one side of the remote replication group (either the primary side or secondary side) but not
on the other side.
Orphan replicated pair virtual disks are detected when inter-RAID controller module communication is
restored and the two sides of the replication configuration reconcile replication parameters.
Use this command when the replicate relationship is successfully removed on the local or remote
storage array, but cannot be removed on the corresponding storage array because of a communication
problem.
Syntax
remove asyncRemoteReplicationGroup ["asyncRemoteReplicationGroupName"]
incompleteReplication virtualDisk="virtualDiskName"
Parameters
Parameter Description
asyncRemoteReplicationGroup
The name of the remote replication group that
contains the orphaned virtual disk that you want to
remove. Enclose the remote replication group
name in double quotation marks (" "). If the remote
replication group name has special characters, you
also must enclose the remote replication group
name in double quotation marks (" ") inside square
brackets.
incompleteAsyncRemoteReplication
The name of the orphaned virtual disk that you
want to remove from the remote replication
group. Enclose the virtual disk name in double
quotation marks (" ").
234
To Next Page
Loading...
Need help?
General
