Parameter Description
NOTE: CopyPriority defines the amount of
system resources used to copy the data
between the source and target virtual disks of
a virtual disk copy pair. If you select the
highest priority level, the virtual disk copy uses
the most system resources to perform virtual
disk copy, which decreases performance for
host data transfers.
targetReadOnlyEnabled
Specifies whether the target virtual disk is write
enabled or read only. To be able to write to the
target virtual disk, set this parameter to FALSE. To
prevent writing to the target virtual disk, set this
parameter to TRUE.
copyType
Creates a virtual disk copy with or a snapshot
which enables you to continue to write to the
source virtual disk while creating the virtual disk
copy. To reinitiate a virtual disk copy with a
snapshot, set this parameter to online. To
reinitiate a virtual disk copy without a snapshot, set
this parameter to offline.
Re-Create Remote Replication Repository Virtual Disk
Description
NOTE: This command is valid only with Fibre Channel storage arrays.
This command creates a new Remote Replication repository virtual disk (also called a replication
repository virtual disk) by using the parameters defined for a previous replication repository virtual disk.
The underlying requirement is that you have previously created a replication repository virtual disk. When
using this command, the replication repository virtual disk can be defined in one of three ways:
• User-defined physical disks
• User-defined disk group
• User-defined number of physical disks
If you choose to define a number of physical disks, the RAID controller module firmware chooses which
physical disks to use for the replication repository virtual disk.
Syntax
User-Defined Physical Disks
recreate storageArray replicationRepository
repositoryRAIDLevel=(1 | 5 | 6)
repositoryPhysicalDisks=(
enclosureID1,slotID1... enclosureIDn,slotIDn)
repositoryDiskGroupUserLabel=[diskGroupName]
[enclosureLossProtect=(TRUE | FALSE)]
229
To Next Page
Loading...
Need help?
General
