Dell PowerVault User Manual

Parameter Description
Valid values for the identifier number are 1 or 2.
Enclose the identifier number in square brackets
([ ]).
file
The name of the file in which you are storing the
results of the fault isolation diagnostics test on the
drive channel. Enclose the name in double
quotation marks (" ").
NOTE: A file extension is not automatically appended to the saved file. You must specify the
applicable format suffix for the file. If you specify a file extension of .txt, then the output is in a text
file format. If you specify a file extension of .xml, then the output is in an XML file format.
Save Physical Disk Log
Description
This command saves the log sense data to a file. Log sense data is maintained by the storage array for
each physical disk.
Syntax
save allPhysicalDisks logFile="filename"
Parameter
Parameter Description
logFile
Name of the file to which to write the log sense
data. You must put quotation marks (" ") around the
file name.
Save RAID Controller Module NVSRAM
Description
This command saves a copy of the RAID controller module NVSRAM values to a file. This command saves
all regions.
Syntax
save controller [(0 | 1)] NVSRAM file="filename"
Parameters
Parameter Description
controller
RAID controller module with the NVSRAM values to
save. Valid RAID controller module identifier values
are 0 and 1. The identifier value is 0 for the RAID
256

Dell PowerVault Specifications

General

RAID Levels	0, 1, 5, 6, 10, 50, 60
RAID Support	Yes
Drive Type	SAS, SSD
Interface	SAS, Fibre Channel, iSCSI
Category	Storage
Connectivity	Ethernet, Fibre Channel
Scalability	Yes
Operating System Compatibility	Windows, Linux, VMware
Management Software	PowerVault Manager, OpenManage