GE Versana Balance User Manual

Connectivity setup
Versana Balance – Basic Service Manual System view 3-99
5808768-100 English Rev.9
3-9-12 Tricefy
New GE Versana ultrasound systems have Tricefy pre-installed.
Additional software is not necessary for using Tricefy; simply
activate your account using the following steps.
1. Press Utility -> Connectivity -> Tricefy.
NOTE: The Tricefy tab is only available on machines that have
Tricefy option.
Figure 3-87. Tricefy Menu
2. Enable Tricefy checkbox, and enter the email address to
authorize the account. Press “ Activate account” to
activate your account, this process may take up to 30
seconds, and a dialog will pop up if succeeded. And you will
receive a notification email, click the link to complete the
whole activating process.
Figure 3-88. Activate Tricefy Account

GE Versana Balance Specifications

General

Category	Ultrasound System
Doppler Modes	Color Doppler, Power Doppler, Pulsed Wave Doppler, Continuous Wave Doppler
Power Requirements	100-240 V AC, 50/60 Hz
DICOM Compatibility	Yes
Wireless Connectivity	Optional
Display	LED
Transducers	convex, linear, phased array
Image Storage	USB
Connectivity	USB, HDMI, Ethernet, DICOM
Applications	Obstetrics, Gynecology, Cardiology, Vascular, Urology
Imaging Modes	2D, M-Mode, 3D/4D
Operating Temperature	10°C to 40°C
Storage Temperature	-20°C to +60°C
Humidity Range	20% to 80% (non-condensing)
Display Size	15.6 inches
Transducer Ports	3 active transducer ports